User guide
Table Of Contents
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Programming
- Programming overview
- About the programming tools
- Enable your options
- Programming the system parameters
- Programming the extensions
- Programming the voice parameters
- Modify the extensions and system directory
- Program the terminal emergency numbers (ELINs)
- About the default line numbers
- Program the general line parameters
- Program the analog lines
- Program the digital trunks
- Assign priority lines
- Restrict external access (toll restriction/call barring)
- Program the voice management parameters
- Programming the voice mail settings
- Setting up the auto attendant
- Configuring call logging (SMDR)
- Programming a loudspeaker
- Committing your changes
- Performing a database backup
- Programming tips
- Chapter 4 Configuring the IP network
- About IP networking
- Network capabilities
- Planning your LAN
- IP programming sequence
- Connecting directly to the Internet
- Connecting to the Internet through an existing LAN
- Using a remote DHCP server
- Changing the assigned DHCP IP address range
- Configuring Domain Name Service
- Assigning a gateway
- Programming dial-up access to an ISP
- Configuring NAT Redirect
- Restricting LAN access (firewall)
- IP networking tips
- Chapter 5 Routine maintenance
- Is the system healthy?
- Is the system secure?
- Checking the system
- Launching the tools
- Enabling your licensed options
- Rebooting the system
- Powering down the system
- Powering up the system
- Upgrading the system
- Performing backups
- Saving call (SMDR) logs
- Using a remote access session
- Changing extensions or set types
- Creating a user guide
- Using a database template
- Maintenance tips
- Chapter 6 Troubleshooting and repair
- Checking the system LEDs
- Checking the logs
- Viewing diagnostics
- Using maintenance commands
- Using Windows networking commands
- Line troubleshooting
- IP port troubleshooting
- IP phone troubleshooting
- Analog phone troubleshooting
- System troubleshooting
- Network troubleshooting
- Fixing database or software corruption
- Replacing faulty components
- Troubleshooting tips
- Appendix A Default database
- Appendix B Reference
- Appendix C Planning
- Index
Technician’s Handbook
116
16. Close all browser windows.
17. Start a new browser and browse to the SonicWall
console at address 192.168.168.1
18. Login to the console.
19. Click the Advanced button on the left side of the
screen.
20. Click the Routes tab near the top of the screen.
21. Click in the Dest Network field in Add Route.
22. Enter address 192.168.1.0 (3100 ICP LAN network).
23. Tab to the Subnet Mask field and enter
255.255.255.0
24. Tab to the Gateway field and enter 192.168.168.2
(address of the 3100 ICP WAN Ethernet interface).
25. Click Update at bottom of window.
26. Restart the SonicWall SOHO2 appliance.
27. Close all browser windows.
Configure the 3100 ICP system with the SonicWALL
SOHO2
1. Configure the monitoring computer's network settings
to Get Address automatically. Then in the DHCP Cli-
ent, add the DNS addresses that were supplied by
your ISP.
2. Connect the computer to a 3100 ICP LAN port. It may
be necessary to open an MS-DOS command window
and type the command ipconfig /renew.
3. Initiate the Internet Explorer browser and click on the
Stop button to prevent it from automatically
connecting to the default web site.