User guide
Table Of Contents
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Programming
- Programming overview
- About the programming tools
- Enable your options
- Programming the system parameters
- Programming the extensions
- Programming the voice parameters
- Modify the extensions and system directory
- Program the terminal emergency numbers (ELINs)
- About the default line numbers
- Program the general line parameters
- Program the analog lines
- Program the digital trunks
- Assign priority lines
- Restrict external access (toll restriction/call barring)
- Program the voice management parameters
- Programming the voice mail settings
- Setting up the auto attendant
- Configuring call logging (SMDR)
- Programming a loudspeaker
- Committing your changes
- Performing a database backup
- Programming tips
- Chapter 4 Configuring the IP network
- About IP networking
- Network capabilities
- Planning your LAN
- IP programming sequence
- Connecting directly to the Internet
- Connecting to the Internet through an existing LAN
- Using a remote DHCP server
- Changing the assigned DHCP IP address range
- Configuring Domain Name Service
- Assigning a gateway
- Programming dial-up access to an ISP
- Configuring NAT Redirect
- Restricting LAN access (firewall)
- IP networking tips
- Chapter 5 Routine maintenance
- Is the system healthy?
- Is the system secure?
- Checking the system
- Launching the tools
- Enabling your licensed options
- Rebooting the system
- Powering down the system
- Powering up the system
- Upgrading the system
- Performing backups
- Saving call (SMDR) logs
- Using a remote access session
- Changing extensions or set types
- Creating a user guide
- Using a database template
- Maintenance tips
- Chapter 6 Troubleshooting and repair
- Checking the system LEDs
- Checking the logs
- Viewing diagnostics
- Using maintenance commands
- Using Windows networking commands
- Line troubleshooting
- IP port troubleshooting
- IP phone troubleshooting
- Analog phone troubleshooting
- System troubleshooting
- Network troubleshooting
- Fixing database or software corruption
- Replacing faulty components
- Troubleshooting tips
- Appendix A Default database
- Appendix B Reference
- Appendix C Planning
- Index
Technician’s Handbook
114
Subnet Mask: 255.255.255.0
Router: 192.168.0.1
11. Next, configure the 3100 ICP.
Appletalk filesharing will not work between the 6000 MAS
and computers that are connected to the 3100 ICP
system. The ServiceLink IPSEC VPN service for
server-to-server connections will not work with this
configuration. Client-to-server VPN connections that use
PPTP will, however, operate normally.
Configure the 3100 ICP
1. Launch the system tool.
2. Choose IP Networking from the Selection menu.
3. Click Router, click IP Routing, click Routing Table,
and then click Add.
4. In the IP Address field, enter the default route
address of 0.0.0.0
5. Enter a Bit Mask of 0.0.0.0
6. In Next Hop, enter the 6000 MAS local IP
(192.168.0.2).
7. Leave the other parameters unchanged and click
Save.
SonicWALL SOHO2
The following instructions refer to the SonicWALL
SOHO2 Internet security appliance only.
Install the SonicWALL SOHO2
Refer to SonicWALL technical documentation for
instructions.