User guide

Configuring the IP network
105
10. Add a new entry for the destination ISP_LINK.
- Set Protocol to “none”.
- Fill in your Local Name and Local Secret name.
These names are your username and password,
respectively, that you received from your ISP.
- For Compression, select either “none” or “STAC”
(STAC Compression may not always work. If it
does become an issue disable it from the remote
client) for compression.
- In the Connect As section, select “client” for the
mode, select “accept IP from remote”.
11. Click Save.
12. Click Destinations, click Remote, click Remote
Destinations, select the ISP_LINK destination, and
then click Change.
13. Click Enable Destination and then click Save.
14. Notice that a default route entry will show up in the
routing table (via NextHop 10.122.122.122). When
stimulus is received and is forwarded through the
default route, either through a browse action or a
ping, the ISP will be dialed and a connection will be
established. Once the connection is established, the
IP address of the interface and entries in the routing
table will automatically be updated with the info
learned from the ISP. NAT will automatically be
added to the interface and is enabled.
You cannot use the special destination ISP_LINK
and the DSL (Net4) at the same time.