User guide
Table Of Contents
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Programming
- Programming overview
- About the programming tools
- Enable your options
- Programming the system parameters
- Programming the extensions
- Programming the voice parameters
- Modify the extensions and system directory
- Program the terminal emergency numbers (ELINs)
- About the default line numbers
- Program the general line parameters
- Program the analog lines
- Program the digital trunks
- Assign priority lines
- Restrict external access (toll restriction/call barring)
- Program the voice management parameters
- Programming the voice mail settings
- Setting up the auto attendant
- Configuring call logging (SMDR)
- Programming a loudspeaker
- Committing your changes
- Performing a database backup
- Programming tips
- Chapter 4 Configuring the IP network
- About IP networking
- Network capabilities
- Planning your LAN
- IP programming sequence
- Connecting directly to the Internet
- Connecting to the Internet through an existing LAN
- Using a remote DHCP server
- Changing the assigned DHCP IP address range
- Configuring Domain Name Service
- Assigning a gateway
- Programming dial-up access to an ISP
- Configuring NAT Redirect
- Restricting LAN access (firewall)
- IP networking tips
- Chapter 5 Routine maintenance
- Is the system healthy?
- Is the system secure?
- Checking the system
- Launching the tools
- Enabling your licensed options
- Rebooting the system
- Powering down the system
- Powering up the system
- Upgrading the system
- Performing backups
- Saving call (SMDR) logs
- Using a remote access session
- Changing extensions or set types
- Creating a user guide
- Using a database template
- Maintenance tips
- Chapter 6 Troubleshooting and repair
- Checking the system LEDs
- Checking the logs
- Viewing diagnostics
- Using maintenance commands
- Using Windows networking commands
- Line troubleshooting
- IP port troubleshooting
- IP phone troubleshooting
- Analog phone troubleshooting
- System troubleshooting
- Network troubleshooting
- Fixing database or software corruption
- Replacing faulty components
- Troubleshooting tips
- Appendix A Default database
- Appendix B Reference
- Appendix C Planning
- Index
Technician’s Handbook
92
Connecting to the Internet through
an existing LAN
You can connect to the Internet through an existing LAN
by using the WAN port or a layer-2 switch (Net 3) port.
Only qualified network engineers should install the
3100 ICP system into an existing LAN.
The 3100 ICP must be physically connected to the
existing network with the correct type of cable before you
begin either of the following procedures.
Through the WAN port
This configuration allows you to connect the 3100 ICP
through the WAN port to a layer-2 switch that is
connected to a router that is directly connected to the
Internet.
Before you begin this procedure, obtain the following
information from the network administrator
- an unused static IP address from the existing LAN
subnet for the WAN port
- DNS addresses
- subnet mask
- default gateway IP address (router connected to
the internet).