User Guide

Mitel Cordless Bluetooth Handset
89
Led Indicator
The cordless Bluetooth handset has two LEDs:
• Blue – indicates the operational status of the handset.
• Green – indicates the status of the electrical charge of the battery.
LED color, states, and indicator descriptions are as follows:
Alerting Tones
The handset provides the following alerting tones:
Powering On/off The Bluetooth Cordless Handset
To power on the Bluetooth cordless handset, place the handset on the IP phone’s cradle.
Mute key Mutes the handset microphone so that your caller cannot hear you.
Volume controls Adjusts the volume for the handset. Press the key above the Mute key to
increase the volume, and press the key below the mute key to decrease
the volume.
LED Color LED State Indicates
Blue
(Handset Not
in Cradle)
Blinking Handset is not connected and is in pairing mode.
Winking Handset is connected, but not in use.
Fading Handset is connected and in use.
Green
(Handset in
Cradle)
Solid Battery is fully charged.
Winking Battery is charging.
Note: It is normal for the handset LED to cycle between winking and solid
as battery charge is maintained.
Off When handset is cradled and the LED does not flash or illuminate, this
indicates absence of battery power. During the first 30 – 60 minutes that the
light is off, the battery may be trickle charging. If that is the case, the LED
will resume normal behavior within that 60-minute period. If the LED
remains off for more than 60 minutes, then either the battery is no longer
chargeable or there is a problem in the charging circuit.
Notes:
• Blinking denotes the LED is alternating very quickly between on and off.
• Winking denotes the LED is alternating between being on for a short period of time and then
off for a longer period of time.
• Fading denotes the LED is alternating between fading in and out.
Event Tone
Power OFF Four tones successively decreasing in pitch.
Mute key on handset ON Two low pitched tones
Feature Description