Programming instructions

SX-200 ICP MX Technician’s Handbook

IP Phones

1. Ensure that the controller is connected to the Layer 2 switch.

2. Plug the cables from the IP phones into the Layer 2 switch ports.

3. Connect the IP Phone to a power source; see page 33 for powering

options.

4. Wait while the IP phone boots. After booting, the display on the phone

shows “USE Superkey TO SEND PIN.” On 5201 IP phones, the MW

lamp is lit.

5. Using the IP phone's dial pad, enter the IP Set Registration PIN access

code (default, ***) followed by the IP Phone extension number.

6. Press Superkey (or Hold for 5201 and 5207 IP phones).The phone is

now ready for use. (The type of phone and its MAC address is

automatically registered with the controller in Form 09)

Note: You MUST use a default IP Phone extension number (102 - 117) or

a number previously programmed in CDE. You cannot use extension

numbers 198 and 199; they are reserved for the Console and Subattendant

station in the default database.