Programming instructions

SX-200 ICP MX Technician’s Handbook

Installing the SX-200 ICP MX Controller

The SX-200 ICP system is shipped with the system software and a default

database installed. The optional components (DSP modules, Analog

Option Module, etc.) are field-installed.

1. Install optional controller hardware or peripheral units according to the

instructions on the pages indicated.

Analog Option Board: page 38

DSP Modules: page 40

Dual FIM Module: page 42

Quad CIM Module: page 43

Dual T1/E1 Framer Module: page 44

Upgraded Internal CompactFlash or Hard Drive: page 45

Stratum Clock Module: see page 47

Network Services Unit, page 53

SX-200 Peripheral Cabinets, age 56.

2. Wall mount the units, rack mount them, or place them on a desk or

shelf; see page 31 for instructions.

3. Connect the ground stud on the rear panel of the controller to a hard-

wired ground using 18 AWG (0.75mm 2/) gauge wire. The wire must

have green or yellow insulation. Crimp the wire to the ground source.

4. Connect a PC to the Maintenance port on the controller; see page 84.

5. Connect the trunks and phones. See “Connecting the Phones and

Trunks” on page 67.

6. If you are NOT installing software or optional hardware in the controller,

power up the system.

Note: Premier Business systems use the Premier database which must be

installed before enabling the MOSS Options. For more information, see

“Installing an Alternate Database” on page 201.

Note: The NSU is NOT wall-mountable.