User guide

Configuring the IP Network
89
Configuring the
IP Network
2. Add the Name, IP address, and Bit Mask to fit your
existing LAN subnet.
3. Ensure that the Advertise as Default Gateway field is
set to This System First.
4. Click Save.
Add the DHCP IP Address range
1. Click DHCP IP Address Range.
2. Click Add.
3. Enter a name for the IP Range.
4. Enter valid Start and End addresses of the IP range.
5. Leave the other parameters at the defaults and then
click Save.
Change the DHCP Options
1. Click DHCP Options in the DHCP Server folder.
2. Select DNS Server from the list of options.
3. Click Change.
4. Change the Value setting to the new IP address that
was configured on NET 3 (from the procedure on
page 88).
5. Click Save.
6. Repeat the above steps to change the DHCP options
for any other servers and IP phones that are defined.
Configure the DNS Server
1. Click DNS and then click DNS Server.
2. Click Change.
3. Enter the Primary and Secondary DNS IP addresses
as supplied by the network administrator.
3100 Hand.bk Page 89 Monday, August 19, 2002 8:49 PM