User guide

Configuring the IP Network
79
Configuring the
IP Network
2. Scroll down the screen to the DHCP section.
3. In the Client Name field, enter the Client Name.
Note that some ISPs and DHCP servers do not
require you to provide a ClientName or ClientID.
4. Click Save.
5. To enable NAT on Net 2
– Click Network Interface and NAT General.
– Click the IP address of the Net 2 destination at the
top of the page.
– Click Change.
– Check the Enable NAT box.
– Click Save.
6. Proceed to Commit your changes (p. 80).
Using Broadband Access (PPPoE)
The following procedure is continued from page 77.
1. In the WAN Ethernet form, choose PPPoE from the
IP Address Source.
2. Scroll down the screen to the PPPoE section.
3. Click Enable WAN Link.
4. Under the PPPoE header, enter your User name and
Password.
5. Enter your Service Name and Access
Concentrator, if applicable.
6. Click Save.
NAT is enabled automatically on Net 2. To enable
NAT on a different Net interface:
– Click Network Interface and NAT General.
3100 Hand.bk Page 79 Monday, August 19, 2002 8:49 PM