User guide

Technician’s Handbook
78
After you select one of the above connection
methods, the “IP Address Source” fields in the other
two methods are ignored by the system.
Using Static IP addressing
The following procedure is continued from page 77.
7. In the WAN Ethernet form, choose Static from the IP
Address Source menu.
8. Scroll down to the Static IP section.
9. Enter the addresses that you obtained from the ISP
– IP Address:
– Subnet Mask:
– Default Gateway:
10. Click Save.
11. To enable NAT on Net 2
–Click Network Interface and NAT General.
– Click the IP address of the Net 2 destination at the
top of the page.
–Click Change.
– Check the Enable NAT box.
–Click Save.
12. Configure DNS with the ISP DNS addresses. See
Configuring Domain Name Service (p. 91).
13. Proceed to Commit your changes (p. 80).
Using DHCP Client
The following procedure is continued from page 77.
1. In the WAN Ethernet form, select DHCP from the IP
Address Source menu.
3100 Hand.bk Page 78 Monday, August 19, 2002 8:49 PM