User guide

Programming

7. For each BRI line, set the Enable Least Cost Routing

option to Yes and click Save.

Configuring PR.Net configuration

With PrNet the default outgoing line access digit (9) must

be set to Secondary in the Number Plan. When a user

dials 9, the request is then routed based on the PrNet

programming.

Any numbers that a user will dial must be in the

VPN/PrNet form. For example, if local calls are 4 and 6,

all other digits must be covered as well, for example 1

through 9, and 0.

If local calls are to be sent over an alternative carrier you

may have to include the full STD code for the local area

in the Repeat Digits. For example, if local numbers begin

with digit 4, and if the STD code for the local area is

01291 and the alternative carrier code is 1690, then the

repeat digits could be 16904 if the carrier supports local

codes or 1690012914 if the carrier does not support local

codes.

1. Choose Voice from the Selection menu.

2. Click Number Plan, select the Leading Digit 9 and

then click Add.

3. Set the Leading Digit Meaning to Secondary and

then click Save.

4. Click VPN/PR.Net and then click Add.

5. Enter the following information:

– Access digits:

– Network Type

– repeat Access digits

– Access Type:

6. Click Save.

3100 Hand.bk Page 57 Monday, August 19, 2002 8:49 PM