User guide

Technician’s Handbook
34
Connect the phones and lines
When you run the system quick installation script, you will
be prompted to connect the IP phones, analog phones
and lines to the system. The system will not automatically
recognize any IP phone that you connect after the
system quick installation tool is finished.
1. Plug the RJ-45 connectors from the IP phones into
the layer-2 switch ports on the controller (see Figure
2) and expansion unit (see Figure 4). The first IP
phone that you connect to the system is assigned as
the administrator station (extension 1000). It’s recom-
mended that you connect a Mitel Networks 5020 IP
phone or 5140 IP Appliance into port 1 of the
controller.
DXUTUVQe\dUhdU^cY_^^e]RUbcV_bdXU9@`X_^UcQbU
QccYW^UTY^dXU_bTUbdXQdi_eS_^^USddXU`X_^Uc
2. Plug the RJ-11 connectors from the analog phones
into the ONS ports on the ONS modules.
3. Plug the RJ-11 connectors from the LS/CLASS lines
into the line ports.
9Vi_e^UUTd_QTTc_]U9@`X_^Uc\QdUbi_eSQ^
bUU^QR\UdXUQed_bUWYcdbQdY_^_`dY_^dXb_eWXdXU
CicdU]D__\3X__cUBhbcT\S\YS[BhbcT\fXST
bTccX]VbS\YS[2WP]VTQ^TdXU^cUd8?bTc
Pdc^aTVXbcaPcX^]T]PQ[TSd_CadT
?^fTaUPX[caP]bUTa)9V`_gUbd_dXUcicdU]VQY\cdXU
?>CcUdS_^^USdUTd_`_bd"UhdU^cY_^!! !Yc
Qed_]QdYSQ\\iS_^^USdUTd_\Y^U!
4. If the system supports Basic Rate Interface (UK only),
plug the RJ-45 connectors from the Basic Rate
Interface (BRI) lines into the BRI modules.
3100 Hand.bk Page 34 Monday, August 19, 2002 8:49 PM