User guide

Technician’s Handbook
152
Using VxWorks networking commands
I_eSQ^Q\c_ecUFhG_b[c^Udg_b[Y^WS_]]Q^Tcd_
XU\`i_eWQdXUb^Udg_b[Y^V_b]QdY_^Q^Tdb_eR\UcX__d
`b_R\U]cI_eSQ^U^dUbdXUV_\\_gY^WS_]]Q^Tc
dXb_eWXQTYQW^_cdYScUccY_^CUUCdQbdY^WQTYQW^_cdYS
cUccY_^`!$#
• versionShow: Displays system software information
• ifShow: Shows information about network interfaces
• arpShow: Lists the ARP cache
• arpFlush: Clears the ARP cache
• routeShow: Lists the routing table
• hostShow: Lists the DNS host table
• reboot: Reboots the 3100 ICP system
• ppp_tune “idle_timeout 180”: Changes the default
WAN line idle timeout (in seconds)
• inetstatShow: Shows all Internet protocol sockets
• tcpstatShow: Shows statistics for IP
• icmpstatShow: Shows statistics for ICMP
• arptabShow: Shows a list of known ARP entries
• dhcp_server_debug=1: Enables debug port that is
located on the 3100 ICP front panel.
• dhcp_server_debug=0: Disables debug port that is
located on the 3100 ICP front panel.
3100 Hand.bk Page 152 Monday, August 19, 2002 8:49 PM