User guide

Routine maintenance
131
Maintenance
Routine
Using a remote access session
You can access the system tool, group administration
tool, and desktop user tools from a remote PC.
To set up the 3100 ICP system to support remote access,
you must set up remote access on the 3100 ICP system
and then set up dial-up access from the remote PC.
Setting up remote access
You cannot perform this setup remotely (that is, you must
perform this procedure on the 3100 ICP system, on site,
before you can gain remote access).
1. Launch the system tool. See Launching the tools (p.
113).
2. Choose IP Networking from the Selection menu.
3. Click Router, click Destinations, and then select
Net5 in the right pane.
4. Click Change.
5. In the Name field, enter “RAS” and click Save.
6. Click Network Interface and then click Add.
7. In the Network Interface page set the following:
– Destination: RAS
– IP Address Source: Static
– IP Address: Enter an IP address that will be used
by the modem interface of 134.22.11.250
– Bitmask: 255.255.255.000
8. Click Save.
9. Under Network Interface, click IP Routing Table and
then click Add.
3100 Hand.bk Page 131 Monday, August 19, 2002 8:49 PM