User guide

Technician’s Handbook
126
14. Power up the 3100 ICP system.
15. Diagnostic information will be displayed on the
screen. When the following text appears:
Recovery Lite Begin
Looking for valid software
Verifying image /ata0/vxWorks
Recovery Lite Success
Press any key to stop auto-boot. .
7
6
5
16. Press any key.
17. Hyperterminal displays “MN3100 ICP->”.
18. Type “syshd” and press the Enter key.
The following prompt is displayed “This will destroy
the contents of your Hard Disk. Do you with to abort
this operation?”
19. Type “N” and press the Enter key to reformat the
system hard drive.
This step destroys the contents of the hard drive.
20. The system begins reformatting the hard disk.
Diagnostics appear on the screen. When the hard
disk is reformatted “MN3100 ICP->” is displayed.
21. Power down the controller and power it back up again
to reboot the system.
The system takes approximately 60 minutes to boot
up with the new flash. After the system has is fully
loaded, the green power LED will be on steady.
22. Launch the system tool and enable your licensed
options. See Enabling your licensed options (p. 114).
23. Re-install the voice mail prompts from your system
software CD-ROM. You must install them from your
& ]Y^
3100 Hand.bk Page 126 Monday, August 19, 2002 8:49 PM