User guide

Routine maintenance
125
Maintenance
Routine
9. Locate dipswitch S1. It’s positioned next to the round
SysID module (see Figure 18).
Figure 18: Location of dipswitch (S1)
10. Set switch 1 (located closest to the printed circuit
card) to ON to allow diagnostic information to be sent
through the lower DB9 console connector.
11. Connect the lower DB9 male connector on the front
panel of the controller to the female COM port on the
laptop using a CAT5 patch cord.
12. Remove the existing flash card and replace it with the
new flash card. If the flash card does not install easily,
you may have it upside down. See Figure 5 for the
location of the flash card.
13. Launch Hyperterminal and connect to the 3100 ICP
system. See Viewing diagnostics (p. 143).
3100 Hand.bk Page 125 Monday, August 19, 2002 8:49 PM