User guide

Configuring the IP Network
95
Configuring the
IP Network
Programming dial-up access to an ISP
To connect a modem to an ISP
1. Launch the system tool.
2. Choose IP Networking from the Selection menu.
3. Click Router, click Destinations and then select an
available destination (from Net 5 to Net 13).
4. Click Change and change the destination name to
ISP_LINK.
5. Click Save.
6. Click Remote Connection and then click Add.
7. Add a new entry for destination ISP_LINK. Set the
Call Type to outgoing and put in your dial string.
Enable the entry.
8. Click Save.
9. Click Remote Security and then click Add.
10. Add a new entry for the destination ISP_LINK.
– Set Protocol to “none” and fill in your Local Name
and Local Secret name.
– For Compression, select either “none” or “STAC”
(STAC Compression may not always work. If it
does become an issue disable it from the remote
client) for compression.
– In the Connect As section, select “client” for the
mode, select “accept IP from remote”.
11. Click Save.
12. Click Destinations, select the ISP_LINK destination,
and then click Change.
13. Click Enable Destination and then click Save.
3100 Hand.bk Page 95 Monday, August 19, 2002 8:49 PM