User guide

Configuring the IP Network

Configuring the

IP Network

Assigning a gateway

Most configurations have either a gateway server or a

DSL router. You can set up the 3100 ICP system to direct

all traffic bound for the Internet through a gateway server

or through a router instead of going through the system’s

WAN port.

If your router or firewall is positioned between your DSL

modem and the 3100 system, connect the system to the

Internet through a layer-2 switch port.

Use the WAN port to connect the system directly to the

Internet through a DSL modem.

1. Launch the system tool.

2. Choose IP Networking from the Selection menu.

3. Click Router, click IP Routing Table, and then click

Add.

4. Enter the following:

– IP Address: (leave as 000.000.000.000)

– Bit Mask Destination: 0.0.0.0

– Next Hop Address: The Next Hop Address is the

IP address of your DSl router or local server that

is connected to the layer-2 switch port on the

controller.

5. Click Save.

6. Click DNS, click DNS Server and then click Change.

7. Enter the following:

– Domain Name: (enter your domain name or

leave it as mitel.com)

– Primary DNS IP Address: (enter the IP address

of your ISP’s primary server or your own DNS

3100 Hand.bk Page 93 Monday, August 19, 2002 8:49 PM