User guide

Mitel 3000
Administrator’s Manual
113
• In default no lines are programmed.
Note: If 23 B-Channels are available and 10 lines are selected then a total of 13 B-Channels are
available to extensions to select for outgoing calls.
If a user selects a Line key of a line that is set as Incoming only, busy tone is returned and the message
'Restricted' is shown on the display.
OUTGOING GROUPS
Outgoing groups programming when T1 is programmed
Individual T1 channels can be programmed into the different line groups.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “Outgoing Groups” is displayed.
• Select “Outgoing Groups” option.
• Select the group you wish to set up. Up to 11 groups can be set up, each with a corresponding access
code, 9 or 760 - 769.
• Select the lines to be in the group.
• The menu updates to show all T1 and the back up CO lines equipped. The lines in the group are
indicated by a “♦”.
• Select the lines that are in the selected group. Lines 1-24 are the T1 lines programmed as equipped in
the Equipped Lines Programming and Lines 25-28 are the CO lines.
In default all lines, T1 and backup are in group 1 selected by dialing 9.
Outgoing Groups when PRI is programmed
In this case all available B-Channels must be programmed into the same line group.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “Outgoing Groups” is displayed.
• Select “Outgoing Groups” option.
• Select the group you wish to set up. Up to 11 groups can be set up, each with a corresponding access
code, 9 or 760 - 769.
• Select either the 'PRI' or the back up CO lines (Line 24 - Line 27).
• If PRI is selected all the available B-channels are placed in the selected group.
In default the PRI and CO Lines are all in Group 1, selected by dialing 9.
LCR CODES
Selecting Lines when T1 is programmed
When the option to select lines is presented the menu is updated to show all the equipped lines.
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Scroll Down and select “LCR Codes”.
• Select “LCR On” to activate the feature.