Specifications

Mitel 3000
Installation & Maintenance Manual
98
7. Press the Scroll Down key () until “Disable Dial tone Detect” is displayed.
8. Select “Dial tone Detection” The lines with “Dial tone Detection” programmed are indicated with a “♦”.
Press the speakerphone key to finish programming.
Programming Long CO Line
This programming option allows the line impedance on the system CO circuit to be adjusted. The Long CO
line is the normal setting for standard business lines connected to the system. The alternative setting should be
chosen in cases where the line impedance is a resistive impedance. This is likely to be the case if the Lines
being used are extension circuits off a parent PABX or an analog port on an ISDN T/A.
1. From the Programming extension, press the PROGRAM key.
2. Press the Scroll Down key () until “System Programming” is displayed.
3. Select “System Programming”.
4. Enter the System Programming Password and select “Lines”.
5. Press the Scroll Down key () until “PSTN Programming” is displayed.
6. Select “PSTN Programming”.
7. Press the Scroll Down key () until “Long CO Line” is displayed.
The lines with Long CO line programmed are indicated with a “♦”.
8. Press the speakerphone key to finish programming.
SIP Called number routing
If the SIP DID or DNIS service is provided by the service provider the calls can be routed to extensions or
groups based on the called number received. (Before programming any DID or DNIS number, the SIP VoIP
Trunk has to be programmed from the Broadband module, please refer on how to program this module from the
Broadband module manual.) A table of 100 entries is provided in the DID/DNIS Table programming option.
Each entry can be programmed to ring a group or extension. Courtesy Service or Auto Attendant can also be
programmed for each number. If the received number does not match an entry in the list the call is presented to
the group or extension programmed for the SIP line in the Incoming Ringing programming. The default group to
ring is Group 1 it has the first 8 extensions in the group.
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “DID / DNIS Table” is displayed.
• Select “DID / DNIS Table”.
• Select an Index Number (001 - 100).
• Enter the DID telephone number.
• Press “Confirm”.
• Enter the name to be associated with the number.
• Press Confirm.
• Select the option “Day Mode”, “Night Mode” or “Day and Night Mode”.
• Select the required option of “Extension”, “Group”, “Auto-Attendant” or “Courtesy Service”.
Note: When selecting “Extension”, only one extension can be selected. If more than one extension is required,
then a group would have to be programmed with the required extensions in the group.
SIP Trunks service provider has to be able to activate this feature.
SIP Trunks should be programmed on the broadband module before SIP Called Number Routing is programmed.
NOTE: From your MPS do not tick the SIP box under the DDI Section if your service provider does not support SIP DID.
To Program Lines to be Answered by the System Voice Mailbox
1. From the programming extension, press the PROGRAM key.
2. Press the Scroll Down key () until “System Programming” is displayed.
3. Select “System Programming”.