Specifications

Mitel 3000
Installation & Maintenance Manual
96
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Press the Scroll Down key () until “Auto Line Selection” is displayed.
• Select “Auto Line Selection On”.
Press the speakerphone key to finish programming.
To turn Off the Automatic Line Selection feature follow the above steps and select the “Auto Line Selection
Off”.
PSTN Programming
This option allows different parameters to be set on standard CO Lines.
Programming Tone Dialing
On standard CO lines on Mitel 3000, the Tone dialing option is programmed. If you program me Tone dialing
off then Pulse dialing is set.
1. From the Programming extension, press the PROGRAM key.
2. Press the Scroll Down key () until “System Programming” is displayed.
3. Select “System Programming”.
4. Enter the System Programming Password and select “Lines”.
5. Press the Scroll Down key () until “PSTN Programming” is displayed.
6. Select “PSTN Programming”.
7. Press the Scroll Down key () until “Tone Dialing” is displayed.
8. Select “Tone Dialing”.
The lines with Tone Dialing programmed are indicated with a “♦”.
To Program Loop Calling on System Lines
This feature is used when specialized lines without dial tone are connected to the system. These can be tie lines or
lines with external ring down equipment. When a line is programmed for loop calling the dialed digits are not
shown on the display.
1. From the Programming extension, press the PROGRAM key.
2. Press the Scroll Down key () until “System Programming” is displayed.
3. Select “System Programming”.
4. Enter the System Programming Password and select “Lines”.
5. Press the Scroll Down key () until “PSTN Programming” is displayed.
6. Select “PSTN Programming”.
7. Select “Loop Calling”
A menu showing the CO lines will be presented. The lines using Loop Calling are indicated by a “♦”. Those
using the standard singling are indicated by a “◊”. Select the lines as required.
Press the speakerphone key to finish programming.
NOTE: Last Number Redial, Call Restriction, Saved Numbers, System and Personal Speed-Dial will not work
on the lines allocated as Loop Calling.