User guide

7
Introduction
About SX-200
®
MyAdministrator
The SX-200 MyAdministrator software application allows the user to perform basic changes to
the telephone configuration. With this application, the user connects to the system site and can
add, move, modify, or delete telephone sets; program, modify, or deprogram telephone features,
and control membership in telephone groups.
Note
Support for devices and features depends on the system and the system software load.
Some devices and features may not be available on your system.
This application can manage the following device types:
- 5010, 5020, 5201, 5207, 5212 Dual Boot, 5215, 5215 Dual Boot, 5220, 5220 Dual
Boot, and 5224 Dual Boot IP Phones
- Sub-attendant variants of the 5020, 5220, 5220 Dual Boot, and 5224 Dual Boot IP
Phones
- 5305 and 5310 IP Board Room Conference Units (seen as 5020 IP Phones)
-ONS Stations
- SUPERSET™ 401 and SUPERSET 4001 (key programming is not supported)
- SUPERSET 410, SUPERSET 4105, SUPERSET 420, SUPERSET 4025,
SUPERSET 4125, and SUPERSET 4090
- SUPERSET 430, SUPERSET 4150, and their sub-attendant variants
- Programmable Key Modules
- SpectraLink NetLink e340, NetLink h340 and NetLink i640 Wireless Telephones
Limited programming is available for the following devices:
- PKM Interface Unit (DSS/BLF Interface Unit or PKM Host in CDE terminology) -
Identified in the Phone Data window. Basic properties can be programmed on the
PKM Interface Unit but the unit cannot be added, deleted, or moved.
- PKM12 - Not identified by the system, but is supported as a PKM48 programmed with
12 keys.
- COV, SUPERSET 3DN, SUPERSET 4DN telephones, DMP Unit - Identified in the
Phone Data window but no programming is available.
- ONS Music Source. Identified by the system, but no programming is available.
The application does not support attendant consoles, data sets, AIMs, and DNIC BLFs.
System Requirements
PC Requirements
- Pentium computer
-32 MB RAM
- CD-ROM Drive