User guide

SX-200 MyAdministrator User Guide
20
To automatically program all connected stations, IP sets, DNIC sets and DMPs:
1. Install all ONS cards, OPS cards and DNIC cards. Do not program stations, IP sets, DNIC
sets or DMPs.
2. Connect the DNIC sets or DMPs to the circuits.
3. Connect the IP sets to the ethernet ports on the LAN.
4. Connect to the system site. If required, see Add a New System Site.
5. From the Configuration menu, select Telephones. A dialog box tells you that the system
will program the connected phones and disconnect the system.
6. Click OK.
- For SX-200 ICP systems, a Configure Telephones window opens. Enter the extension
number for the first telephone that requires programming. The system provides ex-
tension numbers in an incremental order for the other telephones.
- For SX-200 digital set systems, the system programs extension numbers using the
circuit addresses. For example, if the circuit address is 1/1/1 then the extension num-
ber would be 1101.
7. Wait at least ten seconds, and then click Connect to connect to the system site.
8. Log in.
9. Double-click the Phone Data icon. The Phone Data window shows all of the connected
telephones with their extension numbers.