User guide

19
Programming Telephones and Trunks
Automatically
About Programming Telephones Automatically
You can automatically program all installed stations, IP sets, DNIC sets and DMPs. This wizard
does not support Control Over Voice (COV) devices (SUPERSET 4 telephones), Analog
Interface Modules or consoles.
The wizard checks for unprogrammed circuits on all installed and programmed ONS cards,
OPS cards and DNIC cards. Cards that are installed in Spines are not supported.
All unprogrammed circuits are automatically programmed as follows:
- Extension numbers are automatically assigned according to a Bay, Slot, Circuit ad-
dress format "BSCC", where:
- B is the Bay number (1-7)
- S is the slot number (1-8)
- CC is the cct number (01-12)
For example, extension number 2608 is assigned to a phone connected to Bay 2, Slot
6, Circuit 08.
Other parameters for IP sets and DNIC sets are assigned as:
-COS = 2
- COR = 4 for all set types except SUPERSET 430 and SUPERSET 4150
- COR = 5 for the SUPERSET 430 and SUPERSET 4150
- Tenant = 1
Other parameters for ONS and OPS devices are assigned as:
-COS = 1
-COR = 1
- Tenant = 1
Note
Before an extension number can be automatically assigned, the telephone must be physically connected
to the circuit. If no set or console is detected on a circuit, that circuit is skipped and no extension number is
assigned.