User guide

SX-200 MyAdministrator User Guide

Add a New System Site

1. In the Site Navigation window, click System Sites.

2. On the menu bar click System Sites, and then click Add Site. The Add Site window opens.

3. Enter text in Name, Location, and Description for the system site. The Name field is the

only mandatory field.

4. Choose a Connection Type.

-Select Direct (the default setting) for a PC connected directly to the SX-200 system.

-Select Dial-Up for a PC connected to a modem and then the SX-200 system. Selecting

the Dial-Up connection requires the ONS port extension number for the modem con-

nected to the SX-200 system.

-Select Remote Host IP for a PC connected to the LAN for the SX-200 ICP system.

Enter the IP address for the remote host. The IP address associates with a dedicated

port number in the SX-200 ICP.

5. Click Save. The Site Properties window opens.

6. If the site is connected with "Remote Host IP", click the Connect button.

7. If the site is for a "Direct Connection" or "Dial-Up Connection", click Settings. The Settings

window opens.

- Select the Baud Rate, the Data/Parity/Stop, and the Port setting. The default set-

tings are 9600; n,8,1; and COM1 respectively (the Port Setting for a Dial-Up

Connection shows the modem configured on the PC).

- Click OK.

- Click Save.

- Click Close.

The Site Navigation window lists the new system site in alphabetical order. To connect the

new site, see Connect to a System Site.

Connect to a System Site

Note

You can only connect to one system site at a time.

The user name and password is programmed in the SX-200 system. This application uses the same name

and password that provides access to the Maintenance Terminal for the SX-200 system. User names

consist of INSTALLER, MAINT1, MAINT2, SUPERVISOR, and ATTENDANT.

1. Use the Site Navigation window to click on the system site that you want to connect, and

then click the Connect button, or on the menu bar click System Sites, and then click

Connect. The Connect window opens.

2. Enter the user name and password for the SX-200 system.

3. Click OK. The Connect button on the Site Navigation window changes to a Disconnect

button and icons appear under the chosen system site.