User's Manual

OpenMobility SIP Installation, Administration and Maintenance
Aastra DeTeWe Doc-ID: pm-0504 28.11.2006 Page: 42 (52)
• DHCP using the public options 227 and 228.
• Setting the syslog daemon server and port via the web interface.
To set up the syslog via DHCP or OM Configurator has the advantage, that
syslogs are available in earlier states of the RFP start up.
The level of syslog messages in the default state allows the user, to have
control over the general system state and major failures. If it is wished to
increase the level for diagnostic reasons, this can be done via the telnet user
shell by increasing the spy level of each subsystem (see chapter 4.4.5).
You can also read syslogs if you type the command logread within the telnet
user shell.