Use and Care Manual
208
MiTek
®
Product Catalog
Copyright © 2020 MiTek Industries, Inc. All Rights Reserved
EWP Hangers
EWP Hangers
Designed to support LVL, LSL, and PSL beams and headers
in medium load conditions.
Ma terials: See EWP Face Mount Hangers charts, pages 218-220
Finish: G90 galvanizing
Options: See Specialty Options chart
Codes: See chart for code references
Installation:
• Use all specied fasteners. See Product Notes, page 18.
• Min Nailing – Fill all round nail holes.
• Max Nailing – Fill all round and diamond nail holes.
Option
Skewed
1,3
Sloped Seat
2,3
Sloped / Skewed
1,2,3
Inverted Flange
1) Skewed hangers with skews greater than 15° may have all joist nailing on outside flange.
2) Sloped or sloped / skewed hangers with slopes greater than 15° may have additional joist nails.
3) For skewed hangers, the required cut type (square or bevel) of joist member may vary based on skew angle
and width of hanger. Some square cut hangers will require custom pricing due to welded back plate.
4) HD option hangers may be manufactured as welded products to achieve listed loads. Welded products have a primer finish.
Range
Allowable
Loads
See Sloped Seat and Skewed
100% of table load.
75% of uplift load on
skews greater than 15˚.
100% of table load.
65% of table load when
nailing into the support
members end grain.
1˚ to 67-1/2˚
when width is 1-3/4" or less.
1˚ to 50˚ on all others.
2-1/4" widths or greater
(Widths < 2-1/4" may be
available as a Custom, contact
MiTek)
100% of table load
1˚ to 45˚
80% of table load.
75% of uplift load on
skews greater than 15˚.
Ordering
Add
IF,
to product number.
Example: HD410_IF
Add
SK,
angle required,
right
(R)
or left
(L), and
square cut
(SQ) or
bevel cut
(BV)
to product number.
Example: HD410_SK45R_SQ
Add
SL,
slope required,
and up
(U)
or down
(D),
to product number.
Example: HD410_SL30D
See Sloped Seat and Skewed
Example:
HD410_SK45R_SQ_SL30D
Typical HD
installation
Specialty Options Chart – refer to Specialty Options pages 320-321 for additional details.
HD Face Mount Hangers
HD
W
D
H
Additional diamond
nail holes for
max nailing
Standard round nail
holes for min nailing
A