Use and Care Manual

178
Copyright © 2020 MiTek Industries, Inc. All Rights Reserved
Lumber Hangers
Lumber Hangers
MiTek
®
Product Catalog
JPF Purlin Hangers
Materials: 20 gauge
Finish: G90 galvanizing
Options: See chart for Corrosion Finish Options
Codes: IBC, FL, LA
Installation:
• Use all specied fasteners. See Product Notes, page 18.
• Diamond holes allow optional header nailing.
• Joist nails must be driven at a 30° to 45° angle through the purlin
into the header to achieve listed loads. Slant/double shear nails
must be used to achieve listed load values.
• 16d sinkers (0.148" dia. x 3-1/4") may be used where
10d commons are specied with no load reduction.
JPF24
Floor
Uplift
1
Floor
Uplift
1
Ref. No. W H TF Type Qty Type 100% 115% 125% 160% 100% 115% 125% 160%
Min 2 -- 10d 2 10d 1035 1035 1035 315 815 815 815 255
Max 2 2 10d 2 10d 1305 1305 1305 425 995 1040 1040 340
Min 2 -- 10d 2 10d 1035 1035 1035 315 815 815 815 255
Max 2 2 10d 2 10d 1305 1305 1305 425 995 1040 1040 340
1) Uplift loads have been increased 60% for wind and seismic loads; no further increase shall be permitted.
2) JPF cannot be used back to back on a single ply header when optional nailing is used.
3)
NAILS:
10d nails are 0.148" dia. x 3" long.
Corrosion
Finish
PF26 20
2 x 4 JPF24 PF24
Dimensions (in)
Header
2
Joist
DF/SP
Allowable Loads (Lbs.)
S-P-F
Allowable Loads (Lbs.)
Top
Qty
Face
Qty
Fastener Schedule
3
Min/
Max
IBC,
FL,
LA
Roof
Code
Ref.
Purlin
Size
MiTek USP
Stock No. GA
Roof
1-9/16
1-1/16
1-1/16
20 3-3/8
5-3/8
1-9/16
2 x 6 JPF26
Double shear nail design
features fewer nails and
faster installation
Uses standard length
common nails
Typical JPF24
installation
Typical JPF24
back-to-back installation
Corrosion Finish
Stainless Steel Gold Coat
HDG Triple Zinc
Corrosion Finish Stainless Steel Gold Coat HDG Triple Zinc
Corrosion
Finish
Stainless Steel
Gold Coat
HDG
Triple Zinc
TF
H
W
1-1/2"
Raised dimple
allows 30° to
45° nailing