Use and Care Manual

102
Copyright © 2020 MiTek Industries, Inc. All Rights Reserved
Caps & Bases
Caps & Bases
MiTek
®
Product Catalog
KCCQ / KECCQ Column Caps
KCCQT
KCCQO
KECCQLLKECCQLL
rotated 90°
KCCQ
offset right
KCCQC
Optional KECCQ
rotated straps 90°
KECCQLR
KECCQLR
rotated 90°
KCCQ
rotated 45° left
KCCQ
offset left
KCCQOB
KECCQLL
left shown
KECCQ
offset left
KECCQ
offset right
KCCQ
rotated 45° right
Top View of Specialty Options Column Cap Configurations
L
H
W1
Specialty Options:
• KECCQ – Straps may be rotated 90° with no reduction
in published capacity on special orders where the W2
dimension is less than or equal to the W1 dimension.
When W2 is greater than W1 uplift loads may be reduced,
consult MiTek Engineering support.
• KCCQO/KECCQO – Cap only, no strap design for eld
welding to pipe or other columns.
• KCCQOB – For + beam connections. Any two buckets
can be welded together for a wide variety of applications.
Allowable load shall be the lesser of the two components.
• KCCQT – For T beam intersections, consult MiTek.
Specify beam/column conditions, dimensions, and
loading requirements.
• KCCQC – For X beam intersections, consult MiTek.
Specify beam/column conditions, dimensions, and
loading requirements.
• KECCQL – For L beam intersections, consult MiTek.
Specify left (L) or right (R) beam/column conditions,
dimensions, and loading requirements.
Dimension call-outs not shown in the table must be
specied at time of ordering for specialty options,
non-catalog, or rough/full size lumber sizes.
Refer to Options for Multiple-Beam Column Caps
Special Order Worksheet for ordering instructions
at MiTek-US.com on KCCQ/KECCQ Column Caps
web page.
L
H2
W3
W2
W1
H1
W1
W2
W4
W3
H2
H1
H3
4" Typ.
L
W1
W3
W2
H2
H1
L1
L2
H1
H2
W2
W1
L
H
W1