Use and Care Manual

321
Specialty Options
Copyright © 2020 MiTek Industries, Inc. All Rights Reserved
Specialty Options
MiTek
®
Product Catalog
Face Mount Hanger Specialty Details
See the Specialty Options Chart for each hanger series
for load reductions and hanger maximum range of skew,
slope, etc.
Skewed Hanger:
• Consider SKH or SKHH hangers for 45° skews.
• Joist nails on the closed side may be relocated to the
open side by MiTek designer to ensure proper nailing.
• Specify skew angle, type (square cut or bevel cut),
and direction when ordering.
Sloped Seat Hanger:
• Consider LSSH series for sloped applications.
• Additional nail holes may be added to joist anges
by MiTek designer.
• Specify slope angle and direction when ordering.
Sloped/Skewed Hanger:
• See nailing notes above for both Skewed Hanger
and Sloped Seat Hanger.
• Specify skew and slope angles as well as skew/slope
directions and skew type (square cut or bevel cut)
when ordering.
Inverted Flange Hanger:
• When fastening into the carrying member’s end
grain, the allowable load is 0.65 of the table load.
• Hangers with one ange inverted achieve 100%
of listed table load.
• Specify right or left ange when inverting only
one ange.
Refer to GHF, HD, SUH, THD, THDH, THF series Special
Order Worksheet for ordering instructions at MiTek-US.com.
Typical SUH hanger skewed,
right shown
(bevel cut)
Typical HD hanger
sloped seat,
down shown
Typical GHF hanger
one ange inverted,
left shown
Typical SUH formed
hanger skewed,
right shown
(square cut)
Typical HD hanger
inverted ange
90°
Open side
Specify angle
Closed
side
Specify angle
Specify
angle
Plumb
height
Joist
height
2-1/8"
Typical HD hanger
sloped down,
skewed left shown
Slope
angle
Skew
angle
90°
90°