User Guide
Table Of Contents
- 1. Scope
- 3. Firmware:
- 4. Device Name:
- 5. User Interface:
- 5.1. Turn On
- 5.1.1. Power On LED Sequence
- 5.2. Pairing Mode
- 5.2.1. Pairing LED Indication
- 5.2.2. Known Issues
- 5.3. Play/Pause
- 5.3.1. Pause LED indication
- 5.3.2. Play LED indication
- 5.4. Volume Up/Dwn
- 5.6. Mode Button (DSP Toggle)
- 5.7.1. Concert Mode LED indication
- 5.8. Charging Operation
- 5.9. Charge Level Indication
- 5.9.1. Known Issues
- 5.10.1. Power OFF LED Sequence
- 5.11. Audible Prompts
- 5.11.4. Minimum Volume
- 5.11.5. Pairing Mode
- 5.11.8. DSP Tunning
Krill Operational Guide.doc Page 7 of 7 08/26/2022
To assure continued compliance, any changes or modifications not expressly approved by the party.Responsible
for compliance could void the user’s authority to operate this equipment.
FCC Statement
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in the portable exposure condition without restiction.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept
any interference, including interference that may cause undesired operation of the device.
- French:
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitationestautorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d'encompromettre le
fonctionnement.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
le dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.
l'appareil peut être utilisé dans des conditions d'exposition portatif sans restriction.
Resolution 680 statement, below, must be placed in an easily visible place in the product, or in
the user manual:
Regulamento Anatel sobre equipamentos de Radiocomunicação de Radiação Restrita
(Resolução nº 680): “Este equipamento não tem direito à proteção contra interferência
prejudicial e não pode causar interferência em sistemas devidamente autorizados – Para
maiores informações, consulte o site da Anatel – https://www.gov.br/anatel/pt-br/"