User Guide
Table Of Contents
- 1. Scope
- 3. Firmware:
- 4. Device Name:
- 5. User Interface:
- 5.1. Turn On
- 5.1.1. Power On LED Sequence
- 5.2. Pairing Mode
- 5.2.1. Pairing LED Indication
- 5.2.2. Known Issues
- 5.3. Play/Pause
- 5.3.1. Pause LED indication
- 5.3.2. Play LED indication
- 5.4. Volume Up/Dwn
- 5.6. Mode Button (DSP Toggle)
- 5.7.1. Concert Mode LED indication
- 5.8. Charging Operation
- 5.9. Charge Level Indication
- 5.9.1. Known Issues
- 5.10.1. Power OFF LED Sequence
- 5.11. Audible Prompts
- 5.11.4. Minimum Volume
- 5.11.5. Pairing Mode
- 5.11.8. DSP Tunning
Krill Operational Guide.doc Page 7 of 7 08/26/2022
Document Number:
Document Title:
Krill Operational Guide
Revision Level:
A
8/26/2022
Original Created By:
M Harkins
Revised By:
M Harkins
ECO:
5.11. Audible Prompts
Not all the audible prompts have been implemented. The ones that have need to have more
work done on them. Current issues are getting the prompt to enunciate at the proper
volume. With some of the prompts getting proper timing to the LED indications has been an
issue. These should be resolved in the P3 build.
5.11.1. Power On
Custom Sound #1 Volume 30%: Unit plays sound, but at incorrect volume.
5.11.2. Power Off
Custom Sound #2 Volume at 30%: Plays sound, but at incorrect volume.
5.11.3. Maximum Volume
Long Beep at volume level: Not implemented yet
5.11.4. Minimum Volume
Long beep Volume at 20%: Not implemented yet
5.11.5. Pairing Mode
Custom Standard Pairing Sound Volume at 30%: Not implemented yet
5.11.6. Concert Mode Init
Custom Concert Mode Volume 30%: Not implemented yet
5.11.7. Concert Mode Successful
Custom Concert Confirmation Sound Volume at 30%: Not implemented yet
5.11.8. DSP Tunning
Fading and transition sound: It is not possible to produce sound while reprogramming
the amplifier Chip. The unit is muted during this action. We can play a sound prior to
starting, or upon completion, but not during.
Warning
Original Issue Date:
Date Effective: