User Guide

Krill Operational Guide.doc Page 3 of 7 08/26/2022
Document Number:
Document Title:
Krill Operational Guide
Revision Level:
A
8/26/2022
Original Created By:
M Harkins
Revised By:
M Harkins
ECO:
5.3.1. Pause LED indication
Pause is indicated by the Play button continuously turning on then off at a half second
rate.
5.3.2. Play LED indication
The play LED indication is the Play button being lit.
5.3.3. Known Issues
Occasional disconnect for unit LED indication and phone operation (showing paused
while actually playing).
5.4. Volume Up/Dwn
Pressing and releasing either the Volume Up or Volume Down buttons while actively
streaming music from a connected phone, will adjust the output volume up or down.
5.5. Next Button
The Next button will cause the unit to send a message to a connected phone to advance to
the next Song.
5.6. Mode Button (DSP Toggle)
On power up, the unit initializes to the DSP setting that it was in previously. The DSP
Toggle function will toggle between On Vehicle and In Home DSP settings.
5.6.1. Mode Button Indication
The Mode button will be illuminated depending upon which DSP setting is selected. In
the P1 . 8 build the illumination is backwards from what it needs to be and will be
addressed going forward. Currently the button is “ Off” in the On Vehicle mode or
“Ride Mode” and lit in the Off Vehicle mode.
When the button is first pressed, all other buttons will turn off their illumination, and
the “Mode” button will flash “On” and “Off” at a half second rate. The audio will be
muted while the DSP amplifier is reprogrammed. Upon completion of the mode
change, the other button illumination will return to their previous states, and the Mode
button will be either lit, or off depending upon which mode it is in.
NOTE: Currently the unit will power up in the previous mode that was selected and
will remember its current mode when entering shut down. Is this the operation desired
or should the units always power up on a default mode?
Original Issue Date:
Date Effective: