Installation manual
Hardware Installation Manual ADPRO
®
FastTrace™ 2 Series
10 21790_05
Video output
VGA connector; adjustable resolution (up to SXGA)
With MiTAC PH10LU motherboard: DVI-I or DP (DisplayPort)
Video compression
H.264
Audio compression
The audio compression depends on the camera type.
Bandwidth
Remotely adjustable: compression, fps, and quality.
You can specify a bandwidth limit.
Bandwidth consumption
6 fps CIF/SIF: 70 kbps
12 fps 4CIF/SIF: 400 kbps in optimal quality
Recording type
Continuous, on event (e.g. input, motion detection), alarm over IP (S3100),
Presidium
Storage
Max. 4 x 4 TB SATA hard disks. RAID 1 support
Note
You can connect a portable DVD writer to export video
sequences. Use the USB connector on the front, or the
USB connectors on the back of the FastTrace 2.
Remote visualisation
Internet Explorer; Windows XP, Windows Vista, Windows 7,
Windows Server 2003, Windows Server 2008
Management
Internet Explorer (installs XOa client software)
VSKWin software
M3000 software
VideoCentral Platinum
HeiTel EMS software
third-party CMS software
Power supply
100–240 VAC, 50/60 Hz (+80 % efficiency)
Note
The video system must be connected to a
100-230 VAC/16 A mains outlet with proper earth, applying
a separate, locally approved power cord.
Operating temperature
5–40 °C (see Fan Speed Selection on page 29)
Humidity
20–93 % RH (non-condensing)
Dimensions
445 x 132.5 x 300 mm (W x H x D) without flanges
You can fix rubber feet on the bottom. The height is then increased by 2.5 mm.
(*) With an ENTRY system license you can only use 4 analogue cameras, because this is the maximum
number of analogue cameras that is supported by the ENTRY system license. This is for instance the case
with the ADPRO FastTrace 2 Lite.
(**) With an ENTRY system license you cannot use IP cameras, because this is not supported by this
specific system license. This is for instance the case with the ADPRO FastTrace 2 Lite.
Note
You are not allowed to draw any other streams from the IP cameras than those destined for the
FastTrace 2. If you do need to draw other streams from the IP camera for any reason, use the
single stream mode (for more information, see the XOa Client Software User Manual).
If you have to use streams for other applications as well, then also use the single stream mode.