Service manual

Copystar Focus Volume 8 Number 1
Page 5
Procedure for Installation of New Cursor Ass’y
1. Remove the Side Registration Cursor from the existing Cassette.
2. Remove the Cursor Spring C from the Side Registration Button.
3. Assemble the new Cursor Lever with Spring C together with Cursor Ass’y and Cursor Reinforcement using (4)
M3X8 screws (Fig.1). Fit the Cursor Ratchet to the Cursor Reinforcement with the Dev. Rail Pin as shown
below. The final Assembly should look as illustrated below.
4. Fit the new Cursor Ass’y to the Cassette and install the Cursor Mount Base using the two remaining screws.
Ensure that the new Cursor Ass’y moves freely back and forth.
Cursor Mount Base