User`s manual

1. Remove the two screws securing the interface

slot cover on the rear panel (shown) or side

panel (not shown) of the printer and discard the

interface slot cover.

2. Align the edges of the IB-2x board with the rails in the

interface slot and slide the

IB-2x into the printer. Secure

with the two screws removed in Step 1.

Using the Quick Setup Wizard

While the wizard is easy to use, this section provides some additional information on locating and

connecting to the printer. Insert the CD-ROM and select Quick Setup Wizard in the Configuration

section.

The printer selection screen will be displayed (see Fig 1). Quick Setup will discover printers over either

IPX or IP as long as the protocol is installed on the Windows machine running Quick Setup, e.g., if only

IPX is installed, then Quick Setup will find and display only IPX printers.

If a printer is not displayed on the list, an alternate method for connecting is to enter its Ethernet

address in the space provided. The Ethernet address may be found on the IB-2x status page. If an IP

printer is not on the local segment, then it must also have a correctly configured Default Gateway

address, and the network router(s) must be configured to forward IP broadcasts.

If a printer cannot be found by Quick Setup, (e.g. IPX is not in use and IP broadcasts are not for-

warded), then use a web browser or AdminManager for setup. In a web browser, IP broadcasts are not

necessary since the IP address is entered directly. In AdminManager, specific networks may be

defined for searching. See the Security and Followup Management section for more information on

connecting with a web browser or AdminManager.

Supported Connections and Models

Model Network Connections Supported Printers / Digital Copy

IB-20 10baseT/100baseTX/10base2

S/ S 600,

680,

00,

00 ,

50,

800,

3700+, 3750, 3800, 5800C, 5900C, 6300, 6700,

6900, 7000+, 7700, and 9000;DP-1400, DP-

1800, DP-2800+, DP-3600, and Ci1100; KM-

4230 and KM-5230

KM-6230

IB-21 10baseT/100baseTX

FS-1000, FS-1800, FS-3800

IB-2x Hardware Installation

The IB-2x is a slide-in interface board which does not require the removal of the printer’s main board

for installation. These instructions describe the installation into the FS-800 but are similar for any

Kyocera/ Kyocera Mita printer with the slide-in interface.