Specifications

Entering run time The display will change to that shown in Fig. 9.
SET TII1E 10 niIlUTES
tTME/HOLD IÏEXT+
Fig. 9
Entering a brake
rate
The current run time is displayed and may be altered within the following ranges:
0-9.9 minutes and 10-99 minutes, using the numeric key pad. During the run, the
time remaining will be displayed.
If time hold is required, press the LHK A indicated by the prompt 'TIME/HOLD'. In
this case, the time elapsed from the start of the run is indicated.
To alter the next parameter press the RHK A indicated by the 'NEXT' prompt.
The display will now change to that shown in Fig. 10.
SET BRRKE RRTE1
ÏIEXTi
Fig. 10
The current brake rate is displayed and may be altered using the numeric key pad.
Brake rate may be entered within the range of 0 to 3, where
0 = brake off
1 = minimum brake
2 = medium brake
3 = maximum brake
To display new values, press the RHK A indicated by the prompt 'NEXT'.
10