Instructions / Assembly
If the water inlet valve is a 3/8” compression connection, you can connect
the system directly.
outlet hose
is 3/8”
faucet
hose
INSTALLATION STEPS: 1/2” FIP OUTLETINSTALLATION STEPS: 3/8””
1. Turn off the water inlet valve; leave the
faucet ON. Place a towel under your water
inlet valve to catch any dripping water.
3. Connect the filtration system’s
inlet hose with the water inlet valve.
4. Connect the faucet hose with the filtration
system’s outlet hose to complete the setup.
5. Make sure the faucet is turned on and
then turn the water inlet valve
back on to flush the new system for 5
minutes to condition the new filter.
6. Turn off the faucet to pressurize the new
connected system and check
for any possible leakage.
2. Disconnect the faucet
hose from the water inlet valve.
angle valve
outlet is 3/8”
If it is a 1/2” FIP water inlet valve, please get the 1/2” FIP to 3/8” compression adapter.
2. Disconnect the faucet hose from the water inlet valve, aach the 1/2” FIP to
3/8” compression adapter. Make sure the O ring is in postion; apply Teflon
tape at a clockwise direction 7 times only if needed
1. Turn off the water inlet valve; leave the
faucet ON. Place a towel under your water
inlet valve to catch any dripping water.
3. Connect the filter system’s water inlet
hose onto the adapter.
4. Aach the 3/8” compression to 1/2” FIP
adapter onto the filter system’s outlet hose, then
connect the faucet’s hose. Make sure the O ring
is in position; apply Teflon tape at a clockwise
direction 7 times only if needed.