Specifications

Cyrus DAD7 INSTALLATION
5
English
The Cyrus DAD7 may be positioned as a free standing
unit or alongside a partnering Cyrus Dacmaster or Cyrus
PSX-R where used. Never stand the unit on top of a power
amplifier, which may generate heat. The DAD7 must
always sit horizontally on a flat firm surface. (A Cyrus
Isoplat is ideal for this purpose).
Ensure that there is enough clearance above the DAD7 to
allow access to the dust cover when fully open.
The Mains Supply
The moulded IEC connector of the mains lead supplied
should be plugged in to the power inlet
5
on the rear of
the unit. The mains fuse
6
is located on the rear panel
next to the power switch. It must only be replaced with the
following types :
UK/Europe - 230V T100mA/20mm
N.America - 115V T200mA/20mm
Japan - 100V T250mA/20mm
In the U.K., the Cyrus DAD7 comes with the mains plug
fitted. In the unlikely event that the plug fuse should need
replacing ensure that it is only replaced with a 3 Amp
Fuse.
This is an optional connection which enhances and
expands the functional capability of specific Cyrus
products, including your Cyrus DAD7. Through the MC-
BUS and certain ancillary equipment a highly functional
integrated system with full remote control may be set up.
This feature is usable if you also own a Cyrus III
amplifier, Cyrus pre-amplifier, or the Cyrus Systems
Controller.
A pair of quality RCA interconnects are supplied with the
DAD7. Connect one end of each lead to the audio output
sockets of the Cyrus DAD7
2
and the other end to the
corresponding input of the amplifier or receiver. Amplifier
inputs that are suitable for this purpose are CD or AUX
inputs. DO NOT connect the DAD7 to the PHONO input
sockets of the amplifier, as this could damage your
amplifier/speakers.
POSITIONING THE UNIT
CONNECTING THE UNIT
MC-BUS System Connection
Connecting to an Amplifier
Downloaded From Disc-Player.com Cyrus Manuals