Specifications

Cyrus DAD7 OPERATION
9
English
The mains power switch
7
is located on the rear panel of
the player (refer to figure 1, rear panel drawing on page
4).
This switch should be left on for normal operation, except
when left unattended for a long period. In this case the
mains power should be switched off or the product
disconnected from the AC supply.
For the following section, refer to the front panel view on
page 7.
When the Cyrus DAD7 is in regular use and power is
permanently applied, the STANDBY key
12
can be used
to switch the unit on and off. The standby light
1
will
show red when the player is in standby and green when
operating.
First, press the STOP/OPEN key
3
which will raise the
dust cover for a few seconds to allow access for lifting.
Place a thumb under the front edge of the cover and lift
gently until fully open. The cover will latch open.
Remove the disc clamp from the turntable, load a disc
with the label side upward and replace the clamp carefully
over the center of the disc.
Place a finger on the top edge of the cover and pull gently
to release the catch. The cover will now close on its own
accord with a damped action. Do not force the cover to
close as this may damage the internal mechanism.
When the cover is fully closed the disc will spin for a few
seconds, then stop.
Note
:
To prevent any damage to the player or your discs, ensure
that the disc clamp is
always
in place before closing the
dust cover.
To play a disc, press the PLAY key
9
on the front panel.
Playback of a disc will always commence from track 1
unless otherwise selected.
Whilst playing, pressing the PLAY key will re-play the
current track. Refer to the front panel display on page 8
for full details of the display information available during
disc play.
POWER CONTROL
LOADING A DISC
PLAYING A DISC
Downloaded From Disc-Player.com Cyrus Manuals