Operator`s manual

Badger II Power Supply Operator’s Manual
Rev. 05/11/2012 Mission Power Solutions [phone] [e-mail] Pg. 2
Badger II Power Supply
AC-DC Switcher
―Quick Install‖ Instructions
 The Badger can be mounted on either of two sides. Use #8-32 mounting screws. Maximum penetration
should not exceed 0.18″ (4,5 mm).
 Maintain 2″ (50,8 mm) clearance at either end for airflow.
Output Connections
Installing ring lugs and/or bus bars on single output card studs:
 The right stud is Positive and the left stud is the Return on single output
cards.
 Remove the nut and place ring lug over output stud.
 Replace and tighten the nut to a torque of 10 in/lbs. Do not over-
tighten nuts.
Installing power connectors on dual output cards:
 J3-A1 is Positive for output 1 (lower connector); J3-A2 is the Re-
turn. J4-A1 is Positive for output 2 (upper connector); J4-A2 is the
Return. For complete pin assignment, see page 9.
 Use ITT/Cannon mating receptacle P/N DAM7W2PK87 with pins
P/N DM53745-1 or equivalent.
Installing power connectors on quad output cards:
 J3 is a 16-pin Positronics power connector. For complete pin
assignment, see page 9.
 Use Positronics mating connector P/N PLB16M7000 with pins
P/N MC112N.
 Attach 12 AWG wire.
Output
Return
Output
J3
1
8
16
9
J3
Figure 1. Single (Maxi Module)
Output Terminals
Figure 2. Dual (Mini Modules) Output
Connector
Figure 3. Quad (Micro Modules)
Output Connector
J3/J4
Mounting the Badger II Power Supply