Installation Manual

MISHIMOTO | 18 BOULDEN CIRCLE, NEW CASTLE, DE 19720 | P 1.877.GOMISHI | WWW.MISHIMOTO.COM
®
02
05. Release the clips that secure the bottom of the grille, and
remove the grille from the vehicle. Once the grille is removed,
check to make sure the clips are still attached to the radiator
support. Tip: To release the clips, tilt the top of the grille away
from the vehicle, and use a long screwdriver or pry bar and a
twisting motion to release each clip individually.
06. It is possible to remove the transmission cooler without
removing the grille support, but it is a tight fi t. If you want
to skip removing the grille support, proceed to step 13.
07. Remove the eight screws that secure the headlights to the
vehicle. On each headlight, there are two screws along the
top edge, and two along the bottom edge. (8x 5.5mm screws)
08. Pull the headlights away from the vehicle, and disconnect the
electrical harness from the light sockets. Alternatively, you
can leave the connectors attached to the sockets, and remove
the sockets from the headlight. Then set the headlights aside.
09. Remove the eight bolts that secure the grille support to the
vehicle. Pass the headlight electrical harness through the
grille support. (8x 10mm bolts)
10. Release the four tree-clips that secure the shrouding to the
grille support. There are two clips on each side of the grille
opening. (4x tree-clips)
11. Remove the grille support from the vehicle, taking care to
avoid damage to the AC condenser.
CONTINUED ON FOLLOWING PAGE
MISHIMOTO | 18 BOULDEN CIRCLE, NEW CASTLE, DE 19720 | P 877.466.4744 | WWW.MISHIMOTO.COM
'03–'07 FORD 6.0L POWERSTROKE
TRANSMISSION COOLER
INSTALLATION GUIDE