Installation Manual

MISHIMOTO | 18 BOULDEN CIRCLE, NEW CASTLE, DE 19720 | P 1.877.GOMISHI | WWW.MISHIMOTO.COM
®
06
09. Remove the bolt that holds the vehicle horns to the radiator
support. (1x 10mm bolt)
10. Disconnect the hood release cable from its bracket.
11. Remove the upper radiator support from the truck, and
set it aside.
12. Disconnect the power steering line from the radiator.
13. Remove the two bolts that hold the transmission cooler
to the radiator. (2x 8mm bolts)
14. Disconnect the transmission lines from the radiator. Make
sure to have a pan ready, as transmission fl uid will drain.
15. Remove the two bolts that hold the AC condenser to the
radiator. (2x 8mm bolts)
16. Remove the four pop clips that hold the lower side gaskets
to the radiator. (4x pop-clips)
17. Remove the three pop clips that hold the upper gasket
to the radiator. (3x pop-clips)
18. Remove the two bolts that hold the upper fan shroud to the
radiator. (2x 8mm bolts)
19. Remove the two bolts that hold the lower fan shroud.
(2x 8mm bolts)
20. Remove the two bolts that hold the power steering reservoir
to the fan shroud. (2x 8mm bolts)
21. Remove the pop-clips that secure the upper gasket to the
radiator. Remove the upper gasket. (3x pop-clips)
22. Unseat the battery lead, vacuum line and coolant overfl ow line
from the radiator and move them back behind the fan shroud.
23. Remove the upper fan shroud from the radiator.
24. Disconnect the upper radiator hose.
25. Disconnect the lower radiator hose.
26. Carefully remove the radiator from the engine bay. Have
someone help you with this, as the radiator is fairly large.
27. Install the new radiator bushings supplied with your kit.
Failure to install the provided Mishimoto lower radiator
bushings will void the Mishimoto Lifetime Warranty.
CONTINUED ON FOLLOWING PAGE
MISHIMOTO | 18 BOULDEN CIRCLE, NEW CASTLE, DE 19720 | P 877.466.4744 | WWW.MISHIMOTO.COM
'08
—
'10 FORD 6.4L POWERSTROKE
ALUMINUM RADIATOR
INSTALLATION GUIDE