Installation Sheet

PAGE 25
Step 30
Fasten the SCR30 (2) screws to the
track assembly through the bottom
guide.
Step 31
Carefully move each panel to its closed position. As required, slightly loosen the screws in each roller to
adjust each panel. The panels should contact both bumpers on the wall they close against.
After adjustment for gaps at the walls, tighten the screws in each roller back to full tension.
Step 32
Header cut length [HC]:_____________________ (from STEP 7)
Subtract 1/2”
Anti-jump length [AJ]:______________________.
Cut the anti-jump vinyl to length [AJ].
Then cut anti-jump vinyl in half to make two (2) pieces of
equal length.