Installation Sheet

PAGE 24
View from Inside
Step 27
Slightly loosen the screws in both outer panel roller assemblies. Turn the anti-jump stop to vertical
to latch them to the header assembly. It may be necessary to press the door assembly towards
the header at the roller locations. Retighten the screws after adjusting the anti-jump stop.
Adjust the anti-jump stop so
latch seats under lip on header
Step 28
Push the outer panel to the same side as the
inner panel. Slide the bottom guide between
the panels and center it along the length of the
track. Then pre-drill the holes using the 1/8”
drill bit.