Installation Sheet

PAGE 20
Step 22
Untape the hold-downs and slide them to clamp down on the
track tightly, then insert and tighten the SCR30 screw into the
hold-down.
The screw will push against the wall jamb and keep the
hold-down in place.
Step 23
Install the rollers on the outer panel. The rollers will be on the
inside of the shower.
- The rollers are mounted to adjustable cams. Install them
with the rollers at the lowest position.
- Temporarily install the anti-jumps parallel to the floor.
- Only snug the screws for now.
NOTE: There are small part numbers on each part of
the roller. All of them will face the glass.
If using 3/8” glass continue to STEP 24A.
If using 1/4” glass continue to STEP 24B.