Installation Sheet

PAGE 16
Mark from Step 10
holes are to the inside
of the shower
Step 12
Slide the header mount brackets into
each wall jamb. The three (3) holes face
inside the shower.
Align the header mount brackets with the
mark made in STEP 10. Mark the loca-
tions of the mounting as shown.
PRO-TIP: Make the holes near the top of
the adjustment slots. If they are drilled
accurately this will prevent the header
from slipping out of adjustment in the
future.
Step 13
Remove the header mount brackets and drill 1/8” holes at the 4 marked locations. Drill
only through the aluminum wall jamb.
Step 14
For easier installation of the header assembly, install and then remove the four (4)
SCR02 header mount screws.
DO NOT USE A POWER TOOL TO PREVENT STRIPPING THE HOLES
PRO-TIP:
This step pre-threads the
mounting holes to make final
installation easier.
For even easier installation, a
small amount of candle wax or
bar soap on the threads will
make installation of the screw
easier and will help prevent
stripping the head.