Installation Sheet

MOLDED
BUMPER
WALL
JAMB
SCREW &
SPACER
INSERT
TUB
TRACK
GLAZED
PANELS
CENTER
GUIDE
INTERIOR
(2) #6 X 3/8 “
PAN HEAD
SCREW
CAULK
CAU
WALL
JAMB
TUB
TRACK
Step 12
Locate the nylon bottom guide [S] in the middle
of the tub track [A] with the glass panels in the
position shown. With the 7/64” bit, drill two
holes into the V-groove through the mounting
holes in the guide. Install the bottom guide with
two #6 x 3/8” pan head screws [T] through the
drilled holes as shown.
Step 13
Slide the stainless steel bumper inserts [U]
into the four soft vinyl jamb bumpers [V].
Align the slots in the bumpers with the glass
panels and snap the bumpers downward over
the top and bottom wall jamb screws [D] with
the spacers [E].
Step 14
Neatly caulk each end of the tub track [A]
where it meets the wall jambs [B] and the
interior edge of the wall jambs as shown. Run
a bead of caulking the interior edge of the tub
track.
NOTE: The caulking should be allowed to
cure for twenty-four (24) hours before using
your new bath enclosure.
PAGE 9