Installation Sheet

Step 9

Slide one of the clear plastic discs [J], then a glass hole

sleeve [K] onto the back plate [I]. Push the assembly

through the hole in the glass panel, so that the glass

hole sleeve is flush with the other side of the panel.

Slide the other clear plastic disc onto the protruding end

of the back plate, and then slide on the front plate [L].

Repeat this for the second hole on the panel. While

holding the towel bar [N] in place, and screw the back

plates into the towel bar.

NOTE: Outer panel has towel bar facing out. Inner

panel has towel bar facing in. Failure to install handles

properly will inhibit door operation.

Step 10

Before installing the door panels, the proper orientation

should be determined. For maximum waterproofing, the

interior panel should always be positioned closest to the

shower head, as shown in the illustration.

PAGE 7