Installation Sheet

ROLLER
BEARING
HEADER
GLASS
PANEL
ROIRETNI
LENAP
HANGER
BRACKETS
ROIR
ETXE
LENAP
Slide anti-jump stops
into position:
1) at left wall jamb
2) at right wall jamb
3) centered in
opening
Step 7
Insert SCR11 screw into the pre-drilled hole of each insert. The screws will just press against the header. DO NOT
use power tools to insert these screws. DO NOT drill the header for these holes.
PRO TIP!
If the rollers contact the anti-jump
during normal operation, back the
screw out of the insert 1/4 of a turn
at a time until less contact is made.
If the rollers are able to jump from
the track slowly tighten the screw
1/4 of a turn until the roller is unable
to jump from the track.
Textured glass lites [G] should be installed
with the textured surface to the exterior of the
unit. Clear glass does not have a preferred
side to face out, unless glass has been treated
with ClearShield, then that side will face
inward.
If not installed from the factory, install the
hanger brackets onto the glass. On the outside
panel, the roller is installed to the outside. On
the inside panel, the roller is installed to the
inside.
Step 8
PAGE 6